University Park, Maryland
Auto shop and dealership epoxy flooring from University Park crews for the service bays along Baltimore Avenue, built for lifts, oil, brake fluid, and daily vehicle traffic.
A service bay floor takes a specific beating: point loads from lifts, oil and coolant that live on the surface, brake dust ground in by tires, and parts dropped from bench height. Bare concrete absorbs all of it and turns permanently dark in the work lanes.
An auto shop epoxy system seals the slab under a chemical resistant build that fluids sit on top of instead of soaking into. Bays read clean for customers at the counter, and technicians get a brighter floor that shows a dropped bolt or a fresh leak at a glance.
The system is specced around fluids, loads, and light.
A working shop cannot surrender every lift at once. We phase auto shop floors bay by bay, cure each fully before vehicles return, and coordinate the sequence with the service manager in writing.
Showroom and service reception areas can take metallic or fine flake finishes to carry the clean look from the bays to the customer side of the counter.
A four bay service shop on Baltimore Avenue had oil darkened lanes and a patchwork of old paint failing under the lifts. We degreased and ground the slab, reinforced the build in the lift lanes, and finished in blue gray with bay lines striped in. Two bays stayed in service throughout, and fluids now wipe off the sealed surface at cleanup instead of soaking in.
Tell us about your shop and bay count, and we will walk the floor and write a bay by bay phasing plan.
Prefer to talk it through first? Send the form and we will call you back at the number you give us.